![]() This step must be done right or you will not be happy with your rifle, or worse it will not function properly.Īt this point you need to note the factory indentations in the bent top rails. A new Romanian bolt carrier will have no wear, while a Yugo under folder dark bore may have had thousands of rounds fired through it in its past life. ![]() The front support pin and the condition of your parts kits will determine the receivers finished width. All of the flats for sale are made in such a way that there will be extra steel to remove from the two upper rails of the receiver. Mounting the bolt carrier is the most time consuming portion of this build. A finish will be added to the rifle to protect the receiver and match the mounted parts. What needs to be done is to hand fit the bolt carrier assembly into the receiver and mount the barrel. Table of Contents for All Parts of the "Soup to Nuts" Series of Articlesįrom Soup to Nuts Part I: Building an AK-47 Receiverįrom Soup to Nuts Part II: Building an AK-47 Receiver : Heat Treating the Partsįrom Soup to Nuts Part III: Building an AK-47 Receiver : Installing the Railsįrom Soup to Nuts Part IV: Building an AK-47 Receiver : Installing the Front, Rear Trunnion, and Trigger Guardįrom Soup to Nuts Part V: Final Assembly and Finishing Adobe PDF Downloadable Version of Article
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |